Specifications

Maximum Polyphony

8 Voice

LFO

Rate
Delay Time
Delay Time
Trigger Enveloper SW

DCO

Range (64′, 32′, 16′, 8′, 4′, 2′)
LFO Mod
PWM Depth
PWM Source (MAN, LFO, ENV1+, ENV1-, ENV2+, ENV2-)
PWM Level
SAW Level
SUB Level
Noise Level

HPF

Cutoff Freq

VCF

Velocity Sens
Cutoff Freq
Resonance
ENV Mod
LFO Mod
Key Follow

VCA

Velocity Sens
Tone
Mode (ENV1, ENV2, GATE)
Level

ENV1

Attack
Decay
Sustain
Release

ENV2

Attack
Decay
Sustain
Release

Effect

Type (Overdrive, Distortion, Juno Chorus1, Juno Chorus2, Crusher, Phaser)
Tone
Depth

Delay

Type (Delay, Panning Delay, Chorus 1, Chorus 2, Flanger, Delay + Chorus)
Time
Level

REVERB

Type (Ambience, Room, Hall 1 ,Hall 2, Plate, Modulation)
Time
Level

Controller

Bend Sens Pitch
Bend Sens Filter
Mod Sens Pitch
Mod Sense Filter
Portamento
Legato (On, Off)
Bend Range
Bend Gain (1, 2, 3, 4)
Tempo Sync (On, Off)
Key Assign Mode (Mono, Unison, Poly1, Poly2)
Key Hold (On,Off)
Octave (-3, -2, -1, 0, +1, +2, +3)
Condition

Arpeggio

Arpeggio (On, Off)
ARP Type (1Oct Up, 1Oct U+D, 1Oct Down, 2OCT Down, 2Oct U+D, 2Oct Up)
ARP Step (1/4, 1/8, 1/16, 1/4T, 1/8T, 1/16T)

Tune

430.0Hz–450.0Hz

Sampling Frequency

44.1 kHz, 48 kHz

Patches

Preset: 64

Plug-In Formats

VSTi 2.4 (64 bits) * Windows only
VSTi 3.6 (64 bits)
AU
AAX

Plug-Out Hardware

SYSTEM-8

System Requirements (macOS™)

Operating System

macOS 10.14
macOS 10.15
macOS 11

Host Application

VST instruments (VSTi) version: VST 3.6 compatible
Audio Units (AU) version: Audio Units V2 compatible
AAX Compatible

CPU

Intel® Core™ i5 or better (Quad-core CPU recommended)
Apple M1 chip

RAM

4 GB or more

Hard Disk

100 MB or more

Display resolution and Colors

1280 x 800 dots or higher, 16.7 million colors or more

Other

You’ll need Internet connectivity to authenticate this software.
To use PLUG-OUT function, SYSTEM-8 driver installation is needed.

System Requirements (Windows®)

Operating System1

Microsoft® Windows® 8.1 (64-bit)
Microsoft® Windows® 10 (64-bit)*This does not work with the Windows® RT.
*This does not work with the Windows® Phone.
*This does not work on the virtual machines such as Hyper-V, Virtual PC, or Boot Camp.

Host Application

VST instruments (VSTi) version: VST 2.4/3.6 compatible
AAX Compatible

CPU

Intel®  Core™ i5 or better (Quad-core CPU recommended)

RAM

4 GB or more

Hard Disk

100 MB or more

Display resolution and Colors

1280 x 800 dots or higher, 24 bits Full Color or more

Other

You’ll need Internet connectivity to authenticate this software.
To use PLUG-OUT function, SYSTEM-8 driver installation is needed.

1. Although Roland has tested numerous configurations and has determined that on average, a computer system similar to that described above will permit normal operation of the PLUG-OUT SOFTWARE SYNTHESIZER, Roland cannot guarantee that a given computer can be used satisfactorily with the PLUG-OUT SOFTWARE SYNTHESIZER based solely on the fact that it meets the above requirements. This is because there are too many other variables that may influence the processing environment, including differences in motherboard design and the particular combination of other devices involved.

2. This Software Synthesizer cannot be plugged-out to SYSTEM-1 or SYSTEM-1m hardware. If the JUNO-106 is already plugged-out to one of the plug-out destinations of SYSTEM-8 hardware, you cannot plug-out a new instance.

A SYSTEM-8 Hardware synthesizer is not required to use this instrument in your DAW, but is required for this software synthesizer to plug-out to a hardware synthesizer.

Microsoft Windows is a registered trademark of Microsoft Corporation in the United States and/or other countries.VST is a trademark and software of Steinberg Media Technologies GmbH.